NEC Projector 2010 Incorrect power-off Error

2010 Incorrect power-off Error

The 2010 incorrect power-off error is an error code that presents in some late Series 2 as well as NEC laser projectors.  Quite simply put, this error presents when the projector did not go through a proper power off sequence, such as a power failure or by turning off the main power switch without doing a front panel shutdown.  It is the projector's way of saying that if you continue to do this regularly, you may damage the projector.

To clear this message, execute a proper shutdown of the projector:
  1. Shutdown the server user the server manufacturer's recommended procedure.
  2. Turn off the projector from the control panel PJ power switch

  3. Turn off the projector master switch.  On smaller projectors this may be located on the back of the projector on the opposite side from the control panel.  On larger projectors this may be on the operating side of the projector.
  4. Leave the projector off for about 30 seconds.
  5. Turn on the master power switch.  Wait for STANDBY to appear on the LCD panel.
  6. Turn on the projector's PJ power switch.

    • Related Articles

    • NEC Projectors - Preparation for a temporary Shutdown

      For NC1200C, NC2000C, NC3200S, NC3240S, NC900C, NC1100L: If there is an Enigma card (PN# NC-80LB01) in these units, please make sure it is fully charged (48 hrs. of power On should be sufficient). The Enigma charge normally remains for about 6 month, ...

    • NEC S2 Projector Displaying 3xx Error

      NEC errors in the 300 range generally pertain to an issue with the ICP board.  The ICP board contains the projector's security certificate so this can be a fatal one.  There are two batteries on the ICP board.  One battery can be changed, the other ...

    • NEC Cinema equipment installations best practice guidance for extended Off times (ver1 3)

      Guidance for protecting your NEC projection equipment when your theatre/post production installation might be closed for a while Due to the actual force majeure of closing cinema installations for an unknown period of time, we would like to provide ...

    • NEC 900/1100 177 Tamper Fail Error

      When the 177 Tamper Fail error message appears on an NEC NC-900c/1100 projector, it generally indicates that one of the door tamper switches has been tripped.  When the error appears on the side LCD panel or in the Digital Cinema Communicator, it ...

    • 125 LPSU Fail (No Lamp) Message

      While there are a number of reasons that an NEC projector would exhibit an LPSU (Lamp Power Supply) message, there are two that are very common.  The NC1200/2000c projectors feature an external circuit breaker that protects the LPSU.  Although NEC ...