NEC Projectors - Preparation for a temporary Shutdown
For NC1200C, NC2000C, NC3200S,
NC3240S, NC900C, NC1100L:
- If there is an Enigma
card (PN# NC-80LB01) in these units, please make sure it is fully charged
(48 hrs. of power On should be sufficient).
- The Enigma charge
normally remains for about 6 month, before recharge is necessary.
- The ICP board contains
RTC battery, which is good for 6 years and Cert battery for 10 years, both
from manufacture date.
- The CPU board has a
super capacitor for RTC (Real time clock), which holds a charge for about
2 weeks.
- Once the CPU super
capacitor discharges completely; on next boot up it will resync with ICP
RTC.
For NC2041L and NC2402ML:
- The FMT board has a
super capacitor for RTC (Real time clock), which holds a charge for about
2 weeks.
- Once the FMT super
capacitor discharges completely; on next boot up it will resync with IMS
RTC.
- The FMT board also
contains Cert. battery, which is good for 10 years from PJ manufacture
date
For NC1201L, NC1000C:
- The FMT board RTC (Real
time clock) relies on IMS/IMB RTC, it will resync with IMS/IMB RTC during
next bootup.
- The FMT board also
contains Cert. battery, which is good for 10 years from PJ manufacture
date
For NEC IMS (NP90MS02):
- The Cert battery is good
for about a year before recharging is needed.
Related Articles
NEC Cinema equipment installations best practice guidance for extended Off times (ver1 3)
Guidance for protecting your NEC projection equipment when your theatre/post production installation might be closed for a while Due to the actual force majeure of closing cinema installations for an unknown period of time, we would like to provide ...
Lamp replacement NEC NC Series digital projectors
This video, provided by Philips, describes the lamp installation procedure on NEC series 2 projectors. NEC Series 2 Lamp Installation Procedure FYI - Philips digital projection lamps are now sold under the Lighting Technologies International (LTI) ...
Lamp replacement NEC NC Series digital projectors (Ushio video)
This video, provided by Ushio, describes the lamp replacement procedure on NEC series 2 projectors. NEC Cinema Xenon lamp Replacement Procedure (Ushio) FYI - Ushio lamps are available through Total Cinema Solutions.
2010 Incorrect power-off Error
The 2010 incorrect power-off error is an error code that presents in some late Series 2 as well as NEC laser projectors. Quite simply put, this error presents when the projector did not go through a proper power off sequence, such as a power failure ...
Lamp Alignment in NEC Digitial Cinema Projectors
This video, provided by Philips, describes the lamp alignment procedure on NEC series 2 projectors without using the NEC DCC software. NEC Series 2 Lamp Alignment Procedure FYI - Philips digital projection lamps are now sold under the Lighting ...