Touch Panel Controller (TCP) appears dead. Projector is on but cannot be controlled via TPC or net
Christie xenon cinema projectors have three separate power supplies; the lamp power supply (LPS), the low voltage power supply (LVPS) and the standby supply. The standby supply provides power to the touch panel controller (TPC) and the network interface. If this power supply is down the TPC will be off and it will be impossible to connect via the network ports.
Related Articles
Christie Touch Panel Controller displays Windows XP desktop
The touch panel controller (TPC) on Christie Series II projectors runs on a Windows XP Embedded operating system. The older, Series I projectors ran under a Windows CE Embedded operating system. Under normal operation, the operating system is ...
Christie TCP Battery Replacement
The attached document discusses the replacement of the battery on the Christie Touch Panel Controller (TCP). THIS IS A RISKY PROCEDURE AND SHOULD ONLY BE ATTEMPTED BY EXPERIENCED TECHNICIANS. PROCEED AT YOUR OWN RISK. Christie TCP Battery Replacement
Christie Replacing the TPC (Touch Panel Controller) Battery
The linked document covers procedures for changing the battery in the Christie Touch Panel Controller
Christie - Temporary Suspension of your theatre Recommendations
The following recommendations have been provided by Christie for preparing and maintaining your projection booth for an extended shutdown. While theatres are currently suspended from operation, there are a few recommendations we suggest you take to ...
Christie IMB S2 Menu Missing Options
When logged into the TPC (touch panel control) with advanced credentials (ADMIN or SERVICE) as opposed to USER level authorization, the menu only presents the USER level menu options. Normal Christie IMB options when logged in as ADMIN or SERVICE ...